AM/FM Stereo Mate  (120-0169)      Operation           Faxback Doc. # 3722

MANUAL TUNING

Follow these steps to manually tune the radio.

Warning:  To protect your hearing, set the volume control to its lowest
          setting before you turn on the receiver.

1.  Set POWER to ON.

2.  Press AM/FM until the desired AM or FM band appears on the display.

3.  Press TUNING UP ARROW or DOWN ARROW to select the desired station.

    If you press and hold down either TUNING UP ARROW OR DOWN ARROW for
    more than 1/2 second, the tuner quickly scans the frequencies.  When
    you release the button, the tuner automatically locks on the next
    strong station.

4.  Adjust VOLUME to the desired listening level.

5.  To emphasize bass sounds, set E-BASS IN.  To listen to normal sound,
    set E-BASS OUT.

Notes:  To save battery power, set POWER to OFF when you are not using
        your radio.

        When changing and storing stations, you hear a short beep each
        time the UP ARROW or DOWN ARROW tuning button is pressed.
        While scanning, you hear a high-pitched tone as you scan up
        the band and a low-pitched tone as you scan down the band.

        For best FM reception, fully extend the wire antenna or
        headphone cord.

        The AM antenna is built-in.  Rotate the receiver to improve
        AM reception.

        If you are using headphones and want to improve reception for
        weak FM stereo signals, set FM MONO/ST to MONO.  The sound
        becomes monaural (mono).  To return to stereo sound, set it
        to ST.

STORING STATIONS IN MEMORY

You can store one AM and one FM station into each of the six memory
positions.  Then you can instantly tune to the stored station by selecting
the band and pressing the desired memory button.

Follow these steps to store a station in memory.

1.  Set POWER to ON and select the desired band (AM or FM).

2.  Tune to the station you want to store using TUNING UP ARROW or
    DOWN ARROW.

3.  Press MEMORY.  MEMORY flashes for 10 seconds.  While the display
    flashes, press the desired memory button (1-6).

    When you press a memory button to store a frequency, the new frequency
    replaces any frequency previously stored in that memory location.

    Repeat Steps 2 and 3 to store other frequencies in the current radio
    band.  Repeat the entire procedure to store stations in the other
    band.

MEMORY TUNING

To tune to a station you've stored in memory, select the appropriate band
and press the desired memory button (1-6).  The station is immediately
selected and MEMORY remains on the display for 4 seconds before
disappearing.

USING THE LOCK SWITCH

The LOCK switch lets you lock the radio on the current station and disable
the tuning controls on the radio.

To set your radio to LOCK, slide the switch in the direction of the arrow.
You can still adjust the VOLUME, E-BASS, and POWER controls.  To release
the lock, slide the switch away from LOCK.

(br/all-12/20/94)