STAV-3370 Digital Synthesized Stereo (310-3032) Specifications Faxback Doc. # 31167 Amplifier Front Channel Average Power Output:.......110 Watts per Channel into 8 Ohms From 20 to 20,000 Hz, With no more than 0.00% Total Harmonic Distortion Measured Pursuant to the Federal Trade Commission's Trade Regulation Rule on Amplifier Output Power Claims Front Channel Surround Power Output:..................100 Watts per Channel Center Channel Surround Power Output:.............................100 Watts Continuous Rear Surround Power Output:........100 Watts per Channel (1 kHz, 0.8% THD, 8 Ohms) Dynamic Power Output (2 Ohms/4 Ohms/8 Ohms):...........300 Watts/250 Watts/ 150 Watts Input Sensitivity/Impedance: Phono:...................................................2.8 mV/47 kOhms CD, LD, VCR/TAPE 1, Tape 2 Monitor:......................200 mV/47 kOhms Phono Overload Level (0.1% THD, 1 kHz):..............................100 mV Frequency Response: Phono:......................................20 Hz to 20,000 Hz +/-0.3 dB CD, LD, VCR/TAPE 1, TAPE 2 Monitor:..........5 Hz to 100,000 Hz +0/-3 dB Output Level/Impedance: VCR/TAPE 1 REC, Tape 2 Monitor REC:.....................200 mV/2.2 kOhms Tone Controls: Bass:...................................................+/-8 dB (150 Hz) Treble:.................................................+/-8 dB (10 kHz) Super Bass:................................................+8 dB (80 Hz) Signal-to-Noise Ratio (IHF, Short Circuited, A Network): Phono:.............................................................76 dB CD, LD, VCR/TAPE 1, Tape 2 Monitor:................................97 dB Signal-to-Noise Ratio (EIA, at 1 Watt, 1 kHz): Phono:.............................................................77 dB CD, LD, VCR/TAPE 1, TAPE 2 Monitor:................................80 dB Video Section Input Sensitivity/Impedance VCR/TAPE 1, LD:............1 Volt Peak-to-Peak/ 75 Ohms Output Level/Impedance VCR/TAPE 1, LD Monitor:.........1 Volt Peak-to-Peak/ 75 Ohms Frequency Response VCR/TAPE 1, LD Monitor:............5 Hz to 7MHz +0/-3 dB Signal-to-Noise Ratio:................................................55 dB Crosstalk:............................................................55 dB FM Tuner Frequency Range:............................................87.5 to 108 MHz Usable Sensitivity:......................Mono: 11.2 dBf (1.0 microV/75 Ohms 50 dB Quieting Sensitivity: Mono:.......................................16.8 dBf (1.9 microV/75 Ohms Stereo:....................................38.6 dBf (23.3 microV/75 Ohms Signal-to-Noise Ratio: Mono:..................................................73 dB (at 85 dBf) Stereo:................................................70 dB (at 85 dBf) Distortion Stereo:.............................................0.5% (1 kHz) Alternate Channel Selectivity:..............................60 dB (400 kHz) Stereo Separation:............................................40 dB (1 kHz) Frequency Response:................................30 Hz to 15 kHz (+/-2 dB Antenna Input:...........................................75 Ohms Unbalanced AM Tuner Frequency Range:............................................530 to 1700 kHz Sensitivity (IHF, Loop Antenna):...............................350 microV/m Selectivity:..........................................................25 dB Signal-to-Noise Ratio:................................................50 dB General Power Requirements:.....................................120 Volts AC, 60 Hz Power Consumption:..................................340 /Watts, 500 VA (UL) AC Outlet Ratings Switched:.......................Total 100 Watts (0.8 Amps Maximum Dimensions (HWD):.........................6 1/8 x 16 9/16 x 11 13/16 Inches (155 x 420 x 300 mm) Weight:................................................17 lbs. 10 oz (8 kg) Specifications are typical; individual units might vary. Specifications are subject to change and improvement without notice. (SP/LB 03/06/96)