Electronic Portable CD Player Mount for all Cars, Trucks, and RVs 
(420-3051)                 Installation               Faxback Doc. # 32537

INSTALLING THE CD MOUNT

You can install the CD player mount in a variety of locations, such as on
center consoles, transmission humps, under dashboards, and so on.  When
selecting a mounting location, choose an area that is easy to reach and
that does not interfere with your driving.

Hold the supplied platform in several different locations and determine the
mounting method that best meets your needs - base mounting, under dash
mounting, or surface mounting.

BASE MOUNTING

Follow these step to secure the CD player mount to any surface such as a
transmission tunnel or the side of a center console.

  1.  Turn over the platform and decide which set of mounting holes is
      closest to the mounting location.

      CAUTION:  Do not use the under dash extension bracket for base
                mounting.

  2.  Align the two mounting holes in the platform with the two holes in
      the swivel base mounting post.

  3.  Using a Phillips head screwdriver, attach the swivel base mounting
      post to the underside of the platform with the two short self-tapping
      screws.

  4.  Using the swivel base as a guide, drill 1/8 inch mounting holes into
      the desired mounting location.

      CAUTION:  Be careful not to drill into anything behind the mounting
                surface.

  5.  Using a Phillips head screwdriver, attach the swivel base to the
      mounting surface with the four long screws, but do not tighten the
      screws.

      NOTE:  If the mounting surface is too weak to support the screws, use
             the four tinnerman clips for more support.

  6.  Position the platform level with the road surface.

      NOTE:  If mounting the swivel base to the side of a center console or
             transmission hump, position the swivel base with the
             "U-shaped" recess facing upward.

  7.  Tighten the four long screws in the swivel base to secure it to the
      mounting surface.

UNDER DASH MOUNTING

Follow these steps to install the CD player mount under a dashboard, using
the extension bracket attached to the platform.  

  1.  Align the mounting holes in the swivel base mounting post with the
      two holes at the end of the extension bracket.

  2.  Using a Phillips head screwdriver, attach the swivel base mounting
      post to the top of the extension bracket with the two short screws.

  3.  Using the swivel base as a guide, drill 1/8 inch mounting holes into
      the desired mounting location.

      CAUTION:  Be careful not to drill into anything behind the mounting
                surface.

  4.  Using a Phillips head screwdriver, attach the swivel base to the
      mounting surface with the four long screws, but do not tighten the
      screws.

      NOTE:  If the mounting surface is too weak to support the screws, use
             the four tinnerman clips for more support.

  5.  Position the platform level with the road surface.

  6.  Tighten the four long screws in the swivel base to secure it to the
      mounting surface.

SURFACE MOUNTING

To install the CD player mount on a flat surface, such as on a dashboard,
simply insert two of the supplied hook-and-loop tape strips between the
platform and the mounting surface.

NOTE:  Mount the platform on a surface that is level with the road.  Most
       portable CD players do not function properly when mounted at extreme
       angles.

CAUTION:  Do not install on top of dash where outside climate conditions
          reach over 100 degrees Fahrenheit.

MOUNTING YOUR CD PLAYER

Use the supplied hook-and-loop tape strips to secure your portable CD
player to the CD player mount's platform.

CAUTION:  When removing your portable CD player from the platform, always
          use one hand to secure the platform.


(YO/EB 4/23/96)