AM/FM Headset Radio
(120-0916)                 Operation                  Faxback Doc. # 32633

USING THE HEADSET

1.  Press and hold down POWER until the band and station appear on the
    display.

2.  Press BAND to select AM or FM.

3.  Press TUNING DOWN or UP to select the desired station.

    Press and hold down TUNING DOWN or UP for 1 second to quickly search
    for a station.  The headset automatically tunes to the next strong
    station.

4.  Adjust VOLUME on the left earpiece to a comfortable level.

5.  Press POWER to turn off the headset.

    NOTE:  If you do not turn off the headset, it turns off automatically
           in 60 minutes to save battery power.  To continue listening,
           press and hold down POWER until the band and station appear on
           the display.

Listening Safely

To protect your hearing, follow these guidelines when you use headphones.

    Set the volume to the lowest setting before you begin listening.  After
    you begin listening, adjust the volume to a comfortable level.

    Do not listen at extremely high volume levels.  Extended high-volume
    listening can lead to permanent hearing loss.

    Once you set the volume, do not increase it.  Over time, your ears
    adapt to the volume level, so a volume level that does not cause
    discomfort might still damage your hearing.

Traffic Safety

Do not wear the headset while operating a motor vehicle or riding a
bicycle.  This can create a traffic hazard and is illegal in some areas.

Even though you might hear some outside sounds when listening at normal
volume levels, the headset still presents a traffic hazard.

MEMORY TUNING

You can store up to 20 of your favorite stations (10 AM and 10 FM) into
memory so you can easily tune to them.

Storing a Station in Memory

1.  Select the band and station you want to store into memory.

2.  Press MEMORY.  1 appears and MEMORY flashes on the display for about 10
    seconds.

    NOTE:  If you do not make an entry within 10 seconds, MEMORY disappears
           and you must begin at Step 2.

3.  While MEMORY flashes, repeatedly press M-SELECT until the display shows
    the memory location number (1-10 for each band) you want to assign to
    this station.

4.  Press MEMORY again.  The headset stores the displayed station into the
    selected memory location.

    NOTE:  If you assign a memory location number that was previously
           assigned, the new station replaces the old one.

5.  To store additional stations, repeat Steps 1-4.

Tuning to a Stored Station

To tune the headset to a stored station, select the appropriate band and
repeatedly press M-SELECT until the desired memory location number appears
on the display.

To move quickly through the memory locations, press and hold M-SELECT.

LOCKING THE CONTROLS

LOCK/IN/OUT prevents you from accidentally turning the headset on/off or
changing the band, station, or other controls.  But, you can still adjust
VOLUME.

To lock the controls, set LOCK IN/OUT on the right earpiece to IN.  The
LOCK symbol appears on the display.

To unlock the controls, set LOCK IN/OUT to OUT.  The LOCK symbol disappears
from the display.

NOTE:  Automatic power-off works even when LOCK IN/OUT is set to IN.


(RMF/all-05/09/96)