PA Electronic Reverb Control
(320-1107)                 Connections                Faxback Doc. # 32640

CONNECTING THE INPUTS

NOTE:  Use shielded audio cables with phono plug-to-phono plug connectors
       (such as Radio Shack Cat. No. 42-2367).

1.  Connect the output of a cassette deck, pre-amplifier, or other line-
    level source to the reverb control's LINE IN jack.

2.  Connect a microphone's 1/4-inch (6.35 mm) plug to the reverb control's
    MIC IN jack.

You can use LINE IN and MIC IN separately or together.  For example, you
can talk through the microphone input while playing recorded music through
the line input.

CONNECTING THE OUTPUTS

1.  Connect the reverb control's LINE OUT jack to the line input or
    auxiliary input of your cassette deck.

2.  Connect the reverb control's MIC OUT jack to the line input or
    auxiliary input of your receiver/amplifier or PA amplifier.

You can use LINE OUT and MIC OUT separately or together.  For example, you
can record through the line output while listening to your speakers through
the microphone output.

CONNECTING AN ELECTRONIC INSTRUMENT

You can connect your electric guitar or electronic synthesizer to your
electronic reverb control.

1.  Connect your instrument's output to the MIC IN jack on the back of the
    reverb control.

2.  Use a shielded audio cable to connect the reverb's MIC OUT jack to
    the microphone input of your receiver/amplifier or PA amplifier.

You can listen to the reverb control's output on your receiver/amplifier's
speakers while recording the same signal directly from the LINE OUT jack.


(LB/all-05/09/96)