SSM-1200 Stereo Mixer w/7 Band Equalizer
(320-3002)                   Operation                Faxback Doc. # 8755


BASIC OPERATION

You can mix up to six inputs at the same time and use the built-in
equalizer and echo generator to tailor the sound as desired.

1.  Set MASTER to approximately 5.

    NOTE:  The 0.775V/1.5V selector offers an optional input level for
           the master channel.  Set it to 0.775V for high sensitivity
           input, and to 1.5V for low sensitivity input.

2.  Set the switch above each channel VU meter to select the input you
    want to activate.  For example, set CH 1 PHONO/CD/LINE to PHONO when
    you want to mix the audio source connected to the CH 1 PHONO input
    jacks.

3.  Adjust the corresponding volume level control to obtain a reading of
    0 on the output level VU meters.

    NOTE:  The output level VU meter indicates the output signal levels
           of the left and right channels.

4.  Slide the MIC 1 volume level control up to increase, and down to
    decrease the MIC 1 (DJ) microphone's volume.

5.  Push in ECHO BYPASS/ON to produce an ECHO effect; push it out to
    eliminate the ECHO effect.

6.  Push in EQUALIZER BYPASS/ON to ON to operate the right and left
    7-channel frequency equalizer controls.

7.  When two channels are playing at the same time, slide FADER:

       Left, to fade in the volume of CH 1 (or 3) and fade out the volume
       of CH 2 (or 4).

       Center, to mix in the volume of CH 2 (or 4) and of CH 1 (or 3)
       equally.

       Right, to fade in the volume of CH 2 (or 4) and fade out the
       volume of CH 1 (or 3).

       NOTE:  This lets you quickly and smoothly change the mixer's audio
              inputs (PHONO/CD/LINE) from CH 1 to CH 2, or from CH 3 to
              CH 4.

8.  Set MASTER to the desired volume.

9.  Set POWER OFF/ON to OFF to turn off the mixer's power.  The power
    indicator light goes off.


(IR-08/23/96)