STAV-3450  (310-3031)    Training The Remote Control   Faxback Doc. # 9769

You can use your STAV-3450 remote control instead of the ones for other
audio/video components.  To do this, teach your STAV-3450 remote control
the other device's remote control commands.

You can program the commands on the buttons.  By changing the position of
the AUDIO-VCR/TV switch, you can program two commands to a single button.
However, if you program the upper group of buttons with the switch set to
AUDIO, the built-in tuner operations are disabled.

Follow these steps to train the STAV-3450 remote control.

1.  Place both controls about 1 1/2 inches apart with the windows facing
    each other.

2.  Press LEARN on the STAV-3450'S remote control.  The TRANSMIT/LEARN
    indicator flashes.

3.  Select the AUDIO-VCR/TV switch position.  Set the switch to the
    position that best matches the function - to AUDIO for a CD player
    or tape deck and to VCR/TV for a VCR or television.

4.  Within 1 minute, press the STAV-3450's remote button you want to train
    with a pointed object, such as the tip of a pen.  For example, press
    -> to teach this button a new function.  The TRANSMIT/LEARN indicator
    lights steadily.

5.  Within 1 minute, press and hold the other device's remote control
    button you want the STAV-3450 to learn.  The TRANSMIT/LEARN indicator
    flashes.

Repeat Steps 4 and 5 to teach additional commands.

To exit the teaching mode, press LEARN or wait 1 minute.

Notes:  You do not need to turn on the receiver or the other device.

        You might not be able to teach commands from some remotes.

Error Indications:  If the TRANSMIT/LEARN indicator flashes twice in
                    Step 5, the signal might be weak.  Place the remote
                    controls closer together and try again.

                    If the TRANSMIT/LEARN indicator flashes four times and
                    the remote control exits the learning mode in Step 5,
                    the remote control's memory is full.

Programming errors can fill memory.  For example, fluorescent light,
direct sunlight, the two remote controls being too far apart, or a low
battery might cause this error.  Repeat the procedure.

To clear all learned commands from memory, press TV POWER, CD POWER, and
TAPE/VCR POWER at the same time.  The TRANSMIT LEARN indicator flashes
four times.

(br/all-02/22/95)