4-Inch Flush-Mount Speakers For Automobiles & Other Vehicles 
(120-1704)                 Installation               Faxback Doc. # 33328

1.  Select a convenient spot on the door panel to install speaker.  Loosen
    door trim panel and check behind panel to be sure the speaker will not
    interfere with structural members or window mechanism. (1-3/4" (4.5 cm)
    in depth is needed for installation.)

2.  Mark location of four mounting holes and speaker opening at the
    selected spot.

3.  Drill 1/8" (3.5 mm) mounting holes.  Cut the panel using a sharp knife
    or razor blade.

4.  Check front of door for available holes to route speaker leads through.
    If no holes are available, drill a 1/4" - 3/8" (6.5 - 9.5mm) hole close
    to the door hinge.

5.  Route speaker leads into door panel.  Leave a minimum amount of slack
    outside of door and tape the speaker leads to the door hinge.

6.  Run speaker lead from sound system to speaker location.

7.  Attach speaker to door with self tapping screws.  (Install speed clips
    at mounting holes when speaker is being mounted to a non-metal panel.)

8.  Place grille over speaker and snap on.

(SP/EB 6/7/96)