40-Watt Surface Mount  (120-1729)    Installation      Faxback Doc. # 9946
Car Speakers

Before mounting the speakers, we recommend you temporarily connect them to 
your sound equipment and place the speakers where they produce the best 
stereo image.

CONNECTING THE SPEAKERS

Caution:  To avoid possible damage to the  speakers.:

          Turn off power to your sound equipment before connecting the
          speakers.

          Make sure your sound equipment's output impedance matches the
          speakers' impedance of 4 ohms.

          Do not exceed the speakers' total maximum power of 40 watts (20
          watts each channel).

You can use your speakers in a two-speaker or four-speaker system.

Follow these steps to connect a pair of speakers.

1.  Connect the right speaker's black negative (-) wire to your sound
    system's right speaker negative (-) terminal.

2.  Connect the right speaker's black with white strip positive (+) wire
    to your sound system's right speaker positive (+) terminal.

3.  Repeat Steps 1 and 2 to connect the left speaker to your sound system.

Repeat Steps 1-3 to connect an additional pair of speakers to your sound
system.

MOUNTING THE SPEAKERS

After you test the speakers and confirm they operate properly, disconnect
the speakers from your sound system, then follow these steps to mount the
speakers.

Caution:  Be careful not to drill into any wires or other vehicle parts
          beneath the mounting surface.

1.  Mark the positions for the bolt hole and speaker cords at each
    mounting location.

2.  Drill one 3/16-inch bolt hole and one 7/16-inch speaker wire hole at
    each mounting location.

3.  Screw the supplied mounting bolt into the bolt hole on the bottom 
    of the speaker case.  Position the end with the "+" slot facing out
    so you can use a Phillips screwdriver to secure it tightly.

4.  Thread the wiring through the 7/16-inch hole and mount the speaker 
    by inserting the mounting bolt into the 3/16-inch hole in the 
    mounting surface.

5.  Secure the speaker case using the U-type fastener, spring washer,
    and wing nut.

6.  Reconnect the speakers to your sound system (see "Connecting the 
    speakers").

(pm/all-03/03/95)