3830 SL/C  (250-3576)      Using the POWER383 Utility   Faxback Doc. # 1356

┌─────────────────────────────────────────────────────────────────────┐
│                     Power Management Options                        │
│                                                                     │
│ POWER MANAGEMENT                       ON                           │
│                                                                     │
│ SERIAL PORTS                           ENABLED                      │
│                                                                     │
│ HARD DISK TIMEOUT                      1 Minute                     │
│                                                                     │
│ DISPLAY TIMEOUT                        28 Minutes                   │
│                                                                     │
│ STANDBY MODE TIMEOUT                   Never Timeout                │
│                                                                     │
│ RESUME MODE                            OFF                          │
│ SUSPEND TIMEOUT                        Never Timeout                │
├─────────────────────────────────────────────────────────────────────┤
│  ESC TO QUIT,                  USE UP/DOWN ARROWS TO MOVE           │
│  F1 TO UPDATE                  USE LEFT/RIGHT ARROWSTO CHANGE       │
└─────────────────────────────────────────────────────────────────────┘

Note: The 3830SL/C includes Advanced Power Management (APM).  APM helps
save battery power by operating the computer more efficiently.  To enable
APM, add the following line to the computer's config.sys file:

    device=c:\dos\power.exe

To select APM options, type power at the DOS prompt or select the power
icon on the control panel in Windows.

The power program (Power383) lets you temporarily change the power
management parameters without restarting the computer.  These parameters
let you do the following:

* Turn power management on or off
* Turn the floppy disk controller and Resume on or off
* Enable or disable the serial ports
* Set the hard drive, standby mode, and suspend mode timeouts

To run the power program, follow these steps:

1. Exit any program you are running.
2. If you are not in Drive C, type the following: c:<ENTER>
3. Select the DOS directory by typing the following: cd \dos <ENTER>
4. At the prompt, type the following: power383 <ENTER>

(/tmc/BKL-05/31/96)