4033 LX  (250-5130)                 Power               Faxback Doc. # 1642

The 4033 LX has a 200 Watt power supply which is large enough to support a
fully configured system.  Follow these steps for hardware setup.

1.  Plug the power cord into a grounded AC outlet.  Do not use an outlet
    that powers heavy machinery, copiers, office machines, and similar
    devices.  If you must use an extension, use a grounded, multi-outlet
    power strip.

2.  If necessary, use a small screwdriver to set the voltage selector
    switch.  The default is 115V.  Push the switch to the left for 115V
    power or to the right for 230V power, as illustrated:

╔════╤══════════╗             ╔══════════╤════╗
║▒▒▒▒│          ║             ║          │▒▒▒▒║
║▒▒▒▒│  115 V   ║             ║  230 V   │▒▒▒▒║
║▒▒▒▒│          ║             ║          │▒▒▒▒║
║▒▒▒▒│          ║             ║          │▒▒▒▒║
╚════╧══════════╝             ╚══════════╧════╝
                                               
CAUTION:  Voltage requirements vary in different countries.  Be sure to
read the voltage label and set your system accordingly.

If you change the voltage selector switch setting, be sure that you use
the appropriate power cord:

*  FOR UNITS SET AT 115V:  Use a UL-listed cord set consisting of a
   minimum 18 AWG, type SVT or SJT three-conductor cord a maximum of 15
   feet in length and a parallel blade, grounding-type attachment plug
   rated 10A, 125V.  The power cord included with the computer meets these
   requirements.

*  FOR UNITS SET AT 230V INSIDE THE U.S.A.:  Use a UL-listed cord
   consisting of a minimum 18 AWG, type SVT or SJT three-conductor cord a
   maximum of 15 feet in length and a tandem blade, grounding-type
   attachment plug rated 10A, 250V.

*  FOR UNITS SET AT 230V OUTSIDE THE U.S.A.:  Use a cord consisting of
   a minimum 18 AWG and a grounding-type attachment plug rated 10A, 250V.
   The cord set should have the appropriate safety approvals for the
   country in which the equipment will be installed and should be
   marked HAR.

POWER-ON/ POWER-OFF

To turn the computer on or off, press the power switch on the right side
of the front panel.  When the computer is turned on, the power indicator
light is on.

A record of your system configuration is stored in CMOS RAM.  When you
turn on the computer, it automatically runs a series of tests to verify
this information.  If the system configuration does not match the recorded
configuration, the following information is displayed on the monitor:

     BIOS ROM version xx.xx.xx
     Copyright (c) 19xx
     Phoenix Technologies, Ltd.
     All Rights Reserved.
     
     xxxxK Base Memory, xxxxxK Extended
     Invalid configuration information - please run
     SETUP program
     Strike the F1 key to continue

If you receive the preceding system error, you must run the Setup utility
on the Utilities diskette.

(/tmc-05/25/95)