4033 LX (250-5130) Jumpers Faxback Doc. # 1643 You do not need to change the configuration settings (jumper settings) of the computer unless the installation procedure for an option specifically instructs you to do so. Read this section if you need to change a configuration setting. ┌───────────────┬────────────────────────┬────────────────────────────┐ │ FEATURE │ DESCRIPTION │ JUMPER SETTING │ ├───────────────┼────────────────────────┼────────────────────────────┤ │ Monitor Type │ Software selection by │ E11 and E12 installed │ │ │ Setup* │ │ │ ├────────────────────────┼────────────────────────────┤ │ │ Color │ E10 and E11 installed │ │ ├────────────────────────┼────────────────────────────┤ │ │ Monochrome │ E10,E11,E12 no connection │ ├───────────────┼────────────────────────┼────────────────────────────┤ │ BIOS ROM Type│ Do not change, reserved│ E22 and E23 no connection │ │ (256KB) │ for factory use* │ E24 and E25 installed │ ├───────────────┼────────────────────────┼────────────────────────────┤ │ IDE IOCHRDY │ Enabled* │ E1 and E2 installed │ │ ├────────────────────────┼────────────────────────────┤ │ │ Disabled │ E1 and E2 no connection │ ├───────────────┼────────────────────────┼────────────────────────────┤ │ IDE DIAG │ Normal operation* │ E3 and E4 no connection │ │ ├────────────────────────┼────────────────────────────┤ │ │ Diagnostic mode │ E3 and E4 installed │ ├───────────────┼────────────────────────┼────────────────────────────┤ │ I/O Recovery │ Enabled* │ E8 and E9 installed │ │ ├────────────────────────┼────────────────────────────┤ │ │ Disabled │ E8 and E9 no connection │ ├───────────────┼────────────────────────┼────────────────────────────┤ │ System Timing│ Do not change, reserved│ E14 and E15 installed │ │ │ for factory use* │ E17 and E18 installed │ │ │ │ E19 and E20 installed │ ├───────────────┴────────────────────────┴────────────────────────────┤ │ *Indicates factory setting │ └─────────────────────────────────────────────────────────────────────┘ (/tmc-05/25/95)