Tandy 2100
(25-1624)                  Removing Hard Drive         Faxback Doc. # 16814

To remove the hard drive or add system memory:

1.  Turn off all power to the system and peripherals.

2.  Disconnect all power cords and cables from the unit.

3.  Remove the three screws from the rear top of the case and slide the top
    case forward to remove it.

4.  Remove the four screws securing the power supply in the rear.

5.  Push the power supply forward until the front tabs clear.

6.  Lift the power supply out.

7.  If you are removing the hard drive, remove the three screws that secure
    the drive cage to the main chassis, located at the front of the drive
    cage.

8.  Slide the drive cage forward until the hooks on the drive cage clear
    the main chassis holes.

9.  Lift the drive cage up and out.


(TMC/all-09/08/95)