AT&T Globalyst 365TPC
(12-10633)                Shutdown                    Faxback Doc. # 17466

AT&T SHUTDOWN FEATURE

One unique feature the AT&T Globalyst offers is that of an automatic 
shutdown.  When using Windows 95, if you choose to shutdown the computer by
clicking START, then SHUT DOWN, then choosing SHUT DOWN THE COMPUTER, the 
AT&T Globalyst will automatically turn off the computer.  You do not have
to wait for the screen that says It is Now Safe to Turn off Your Computer.

When Windows is ready to display that message, it sends a signal to the
computer, and it is automatically turned off completely.  You would still 
need to turn off your monitor. 

If you open the computer's case and look inside, you will see a purple and 
black cable going from the power supply to the main logic board.  This is 
the wire that performs the above function.  If this wire is unplugged, the
computer will not even power up. 

If someone complains about not being able to power up the computer after 
adding new hardware or going inside the computer for any reason, be sure 
that this cable is properly plugged in.

If the power management featuresare enabled in the computer's CMOS setup, 
you will get a message at the bottom of the screen just after power up that
says Press F2 to enter setup.  
   At this time, press F2 to get into Phoenix BIOS Setup.  Press the right 
   arrow key to select POWER.  On this screen, APM Interface is already
   highlighted.  Press the + or - key (plus or minus) to change from
   DISABLED to ENABLED.  Once changed, press the right arrow again to get 
   to EXIT.  Save Changes & Exit is already highlighted. Hit ENTER.
   A NOTICE box comes up and says Changes Have Been Saved, and the word 
   CONTINUE is highlighted.  Hit ENTER again. The computer will reboot 
   with the saved changes.   

The connector will only fit one way, so just ensure it is on correctly.  
Note that this cable must be plugged in whether the APM features are 
enabled or disabled.


(PB/all-10/17/95)