Packard Bell Force 862CDT      
(12-10641)                 Settings                   Faxback Doc. 17479

Connectors and Jumpers

Your system's motherboard (main circuit board) contains several connectors
and jumpers which can be selected or set differently to give your computer
more flexibility. These settings have been set to the factory default which
most often gives the best performance. You should not alter these settings
unless you have had previous experience with this type of equipment.

WARNING:  Electro-Static Discharge (ESD) -- Before installing or touching
          any exposed printed circuit boards, computer parts, chips, etc.,
          make sure that you are properly grounded. This is extremely
          important, as most internal computer components are highly
          susceptible to damage from Electro-Static Discharge (ESD).

Service technicians ground themselves by wearing an wrist strap (available
at electronics supply stores) which is connected to an electrical ground
(such as your system's Serial Port A). If you do not have a wrist strap,
you can ground yourself and dissipate any electro-static build-up by doing
the following:

1.  Connect the computer's power cord between the computer and a
    three-pronged (grounded) electrical outlet.

2.  Power to the computer must be turned OFF.

3.  Touch, and maintain continuous contact with, an exposed metal surface
    of the computer system (such as the disk drive mounting tray, the
    metal surrounding the power supply or the unpainted portions of the
    computer's rear panel) while handling or touching any internal
    components, chips, add-on boards or disk drives.

Before you begin, make a note of what the original settings are. This way,
you can always revert to the original settings if the new settings do not
work.

J5A2     Flash RCVR                 1-2 Normal
                                    2-3 RESERVED
SW1E1-8  CPU Clock A                OFF: 50/60MHz
                                    ON: 66MHz
SW1E1-7  CPU Clock B                OFF: 50-66MHz
                                    ON: 60
SW1E1-6  Clock Frequency Multiplier OFF: 1.5x
                                    ON: 2x
SW1E1-5  Setup                      OFF: Enable Setup (default)
                                    ON: Disable Setup
SW1E1-4  CMOS                       OFF: Normal (default)
                                    ON: RESERVED
SW1E1-3  RESERVED                   OFF: RESERVED
                                    ON: Disabled
SW1E1-2  ISA Speed                  OFF: 50MHz
                                    ON: 60/66 MHz
SW1E1-1  RESERVED                   OFF: RESERVED
                                    ON: RESERVED
J1J1     VA/VRE CPU                 1-2: 3.3v
                                    2-3: 3.45-3.6v
J13G1    Speaker Connector 3-4 IN:  Onboard Speaker Enabled (default)
                                    Onboard Speaker Disabled

Modem / Sound Board

JMPBO

JMPBO               Base Address
 1-2                22Xh
 2-3                24Xh

JMPCFG

JMPCFG              CONFIG MODE
 1-2                EEPROM Setting
 2-3                Software Setting

Serial Port Setting

JM1       JM2
1-2       1-2       Com1             (Default)
2-3       1-2       Com2
1-2       2-3       Com3
2-3       2-3       Com4

Modem IRQ  Setting Jumper

  IRQ2    IRQ3       IRQ4     IRQ5     IRQ11    IRQ12    IRQ15
                    Default


(rcb/all-10/17/95)