3100 SB Audio Card (250-1632) Specifications Faxback Doc. # 3161 SOUND CAPABILITIES 11-VOICE FM MUSIC-(ADLIB COMPATIBLE) -Frequency Modulation sound generation for realistic sounds. -Two modes: Nine melody sounds or six melody sounds and five rhythm sounds supported by numerous games and entertainment software. 1 DIGITIZED VOICE CHANNEL (8 BIT DAC) -Provide output of sound sampled from the real world-speech, special effects, animal sounds, thunderstorm. -Programmable variable sampling rate 4KHz to 44.1 KHz. DAC TRANSFER MODES -Direct mode- Direct single byte transfer by CPU. -DMA mode - No CPU intervention/overhead required. COMPRESSION SCHEMES -8 bit data, no compression. -2 to 1 data compression - 4 bit ADPCM, hardware decompression. -3 to 1 data compression - 2.6 bit ADPCM, hardware decompression. -4 to 1 data compression - 2 bit ADPCM, hardware decompression. BUILT-IN STEREO POWER AMPLIFIER -Max output: Four watts per channel, four ohms stereo output. -Stereo headset connector drives, speakers, portable speakers or headsets directly. BUILT-IN MANUAL MASTER VOLUME CONTROL VOICE INPUT (DIGITAL SAMPLING) CAPABILITY 8-BIT A-D CONVERSION OF SOUND SIGNAL Variable sampling rate: 4 kHz to 15 kHz. -ADC transfer modes: Direct mode, DMA mode with no CPU intervention required. ADC TRANSFER MODES -Direct mode. -DMA mode - No CPU intervention required. BUILT-IN MICROPHONE AND LINE-IN JACKS WITH AGC (AUTOMATIC GAIN CONTROL) -For direct input (sampling) of sound/speech through standard microphone or from other device (600 ohms impedance). Microphone input 0.004 to 0.7Vrms Line-in, 39K Ohms, with a range of 0.2 to 5Vrms. PORT OUTPUT JOYSTICK PORT -Standard Game I/O port built-in (15 pin D-sub connector). Connects any standard IBM compatible joystick (analog). MIDI INTERFACE -Built-in MIDI interface, for connection to MIDI instruments or keyboards. (Requires optional MIDI Kit). OPTIONAL D/MS 12-VOICE STEREO MUSIC C/MS OR GAME BLASTER COMPATIBLE CHIP KIT -Two optional C/MS music synthesizer chips that plug into the empty sockets on the CT1350 card. (Optional kit consists of two C/MS chips and one other chip). HARDWARE DATA The CT1350 uses the I/O ports addresses 220H and 240H. These are jumper selectable. Factory default is 220H. The following table list I/O addresses and functions. ┌───────────┬────────────────────────────────────┬──────┐ │I/O ADDRESS│DESCRIPTION │ACCESS│ ├───────────┼────────────────────────────────────┼──────┤ │2X0H │C/MS Music Voice 1-6 data port. │Write │ ├───────────┼────────────────────────────────────┼──────┤ │2X1H │C/MS Music Voice 1-6 register port. │Write │ ├───────────┼────────────────────────────────────┼──────┤ │2X2H │C/MS Music Voice 7-12 data report. │Write │ ├───────────┼────────────────────────────────────┼──────┤ │2X3H │C/MS Music Voice 7-12 register port.│Write │ └───────────┴────────────────────────────────────┴──────┘ ┌───────────┬────────────────────────────────────┬──────┐ │I/O ADDRESS│DESCRIPTION │ACCESS│ ├───────────┼────────────────────────────────────┼──────┤ │2X8H │FM Music - Status Port. │Read │ │ │ │ │ │2X8H │FM Music - Register Port. │Write │ │ │ │ │ │2X9H │FM Music - Data Register. │Write │ │ │ │ │ │2X6H │DSP Reset. │Write │ │ │ │ │ │2XAH │DSP (Voice I/O & MIDI Read Data. │Read │ │ │ │ │ │2XCH │DSP Write Data or Command. │Write │ │ │ │ │ │2XCH │DSP Write Buffer Status (bit 7). │Read │ │ │ │ │ │2XEH │DSP Data Available Status (bit 7). │Read │ └───────────┴────────────────────────────────────┴──────┘ NOTE: The above table applies only when C/MS chips are present. (SMC-05/03/94)