3100 (250-1632) Specifications Faxback Doc. # 5517 System Unit Specifications: Processor...........................................................486 SX Processor with Internal Math Coprocessor............................487 SX Overdrive Processor Supported..........................................Yes Clock Speed......................................................25/33 MHz FCC Class.....................................................B, UL Listed Wait States..............................................................0 Built-In: VGA compatible video.....................supports all standard VGA, EGA CGA, and MDA graphics modes Video Chip Set.........................................CL-GD5426-80QC-A Floppy disk controller......................can support 2 floppy drives (1) 1.44 MB Floppy installed NOTE: The Floppy drives require the cable that has the twist in it. This means that both floppy drives must be set for DS1. The drive on the end of the cable will be drive A:. SmartDrive connector...........................can support 2 hard drives Device Expansion.........................1 open 5 1/4 inch half height bay Number of Expansion Slots....................................1 half length 2 full length T compatible 16-bit slots Memory: Base Memory............................................4 MB (64 MB max) Video Memory..........................................512 KB (1 MB max) Cache Memory.......................................................8 KB IDE Hard Drive.....................................................212 MG Keyboard..................................................101 Key Enhanced Standard Ports: VGA Monitor................................................DB-15 female Serial (2)....................................................DB-9 male Bidirectional Parallel.....................................DB-25 female Keyboard and Mouse...................................(2) 6-pin Mini DIN Bundled Software................................................MS-DOS 6.0 Sound Blaster Audio Utilities and VGA Drivers Microsoft Windows 3.1 installed on the hard disk drive Power Requirements.............................. 10 to 125 VAC, 60 Hz (US) (switch selectable) 220 to 240 VAC Power Supply Wattage.............................................145 Watts Heat Output...................................................383 BTU/hour Weight..............................................................23 lbs Dimensions..................................15 X 15.5 X 4.2 inches (LxWxH) Environment: Temperature: Operating................................................50°F to 95°F Storage..............................................-40°F to 158°F Humidity Operating.................................20% to 80% (non-condensing) Storage................................. 0% to 95% (non-condensing) Expansion Slot Current Use ┌────────┬────────────────────┬────────────────────┬───────────────────┐ │Voltage │ Max. Current │ Typical Current │ Max. Total │ │ │ Available per │ Available per │ Current Available │ │ │ Expansion Slot (A) │ Expansion Slot (A) │ for All Slots (A) │ ├────────┼────────────────────┼────────────────────┼───────────────────┤ │ + 5 │ 6 │ 3 │ 9 │ ├────────┼────────────────────┼────────────────────┼───────────────────┤ │ + 12 │ 0.9 │ 0.3 │ 0.9 │ ├────────┼────────────────────┼────────────────────┼───────────────────┤ │ - 12 │ 0.15 │ 0.05 │ 0.15 │ ├────────┼────────────────────┼────────────────────┼───────────────────┤ │ - 5 │ 0.15 │ 0.05 │ 0.15 │ └────────┴────────────────────┴────────────────────────────────────────┘ Heat Sink Requirements for Upgrade Processors Dimensions in inches: ┌──────────┬─────────┬─────────┬───────────┐ │ │ Height │ Width │ Length │ │ Minimum │ 0.32 │ 1.5 │ 1.5 │ │ Maximum │ 0.4 │ 1.7 │ 1.85 │ └──────────┴─────────┴─────────┴───────────┘ To attach a heat sink to an upgrade processor, use a clip with thermal grease, or apply thermal double-sided tape. Acoustic Noise.............................................Less than 42dBA (smc/tmc-03/03/95)