Sensation!  (250-1651)          CMOS Battery           Faxback Doc. # 9671

NOTE: The replacement battery can be ordered through National Parts under
      Part Number CS-1005, Catalog Number 250-1651.

      To clear CMOS, remove the battery, wait 10 minutes, then replace
      the battery.

REPLACING THE BATTERY

Each time you turn on the computer, it accesses a battery-backed memory
chip (CMOS RAM) that contains information about your computer
configuration.  The CMOS RAM battery also powers a real-time clock that
keeps the system time and date.

When the battery fails, the computer loses the configuration and the time
and date information each time you turn off the computer.

Warning:  Improper handling of this lithium battery can be hazardous.
          Never recharge, disassemble, or heat the battery above 100
          degrees C. (212 degrees F.).  Never solder directly to the
          battery or expose the contents of the battery to water.  Dispose
          of used batteries according to the manufacturer's instructions.
          Replace the battery with a battery of the same type.

Caution:  To remove and replace the battery you must remove the upper
          drive support, and the adapters in the two-slot area.
          Reinstalling the adapters requires careful cable reconnection
          and rerouting.  To ensure proper reinstallation of the FAX/modem
          and audio adapter cables, see your computer dealer to have a
          replacement battery installed.

To replace the battery:

1. Open the computer. Remove the upper drive support, and the adapters in
   the two-slot area.

2. Carefully lift the battery clip, and remove the old battery from the
   socket.

3. Insert the new battery, positive (+) side up.

4. Reinstall the adapters in the two-slot area, and the upper drive
   support.

5. Reconnect all cables

6. Close the computer.

7. Run the setup utility to enter the correct time and date.

(JLC-01/24/95)