Flame Thrower II  (600-4138)        Operation          Faxback Doc. # 15186

DRIVING THE FLAME THROWER II

The Flame Thrower II works best on a clean, flat surface.

WARNINGS:  Never play with the Flame Thrower II in the street.  Never drive
           the Flame Thrower II in water.

1.  Fully extend the transmitter's antenna.

2.  Set H-L as follows.

    H (High) For driving on a smooth surface.

    L (Low) For driving on a rough surface.

NOTE:  If you cannot easily move the H-L switch, turn the Flame Thrower
       II's back wheels by hand.  Then try again.

3.  Set the Flame Thrower II's ON/OFF switch to ON.

4.  Use the transmitter's control levers as follows:

Left Control Lever

Push forward to move forward (F).

Pull further forward for turbo power (TURBO).

Pull backward to move backward (B).

Release to stop (STOP).

RIght Control Lever

Push left to move left (L).

Push right to move right (R).

Release to go straight (S).

5.  When you finish driving the Flame Thrower II, set ON/OFF to OFF.

WHEEL ALIGNMENT

If the Flame Thrower II does not go in a straight line when you release
the right control, adjust the wheel alignment control on the bottom of the
Flame Thrower II.

Slide the lever to the right or left until the front wheels are in line
with the vehicle's rear.


(LB/all-05/08/95)