Breeze Runner  (600-4139)         Battery              Faxback Doc. # 16318

NOTE:  You need two AA batteries to power your Breeze Runner, and one
       9-volt battery to power the transmitter.

INSTALLING BATTERIES

CAUTIONS:  Use only fresh batteries of the required size and type.

           Do not mix old and new batteries.

           Never leave dead or weak batteries in the Breeze Runner or the
           transmitter.

           If you do not plan to use the Breeze Runner for several days,
           remove the batteries.

           Dispose of batteries promptly and properly; do not bury or burn
           them.

INSTALLING THE BREEZE RUNNER'S BATTERIES

You need two AA batteries to power your Breeze Runner.  We recommend
alkaline batteries, such as Radio Shack Cat. No. 23-557.

1.  Set OFF/ON on the bottom of the Breeze Runner to OFF.

2.  While pressing down on the arrow on the battery compartment cover,
    slide the cover toward the back of the Breeze Runner until it stops. 
    Then pull down on the cover to open it.

    CAUTION:  The battery compartment cover is hinged.  Do not try to
              remove it.

3.  Install the batteries on top of the ribbon as indicated by the polarity
    symbols (+ and -) marked inside the compartment.

4.  Push up on the cover and slide it forward to secure it.

NOTE:  To remove the batteries, open the battery compartment cover and
       gently pull on the ribbon.

INSTALLING THE TRANSMITTER'S BATTERY

The transmitter uses one 9-volt battery.  We recommend an alkaline battery,
such as Cat. No. 23-553.

1.  While pressing down on the battery compartment cover, slide it down to
    remove it.

2.  Install the battery as indicated by the polarity symbols (+ and -)
    marked inside the compartment.

3.  Replace the cover.  Be sure it snaps into place.


(ALL-08/04/95)