Air Rammer
(600-4140)                 Batteries                  Faxback Doc. # 32010

Note:  You need two AA batteries to power your Air Rammer, and one 9-volt
       battery to power the transmitter.

INSTALLING BATTERIES

Cautions:  Use only fresh batteries of the required size and type.

           Do not mix old and new batteries.

           Never leave dead or weak batteries in the Air Rammer or the
           transmitter.

           If you do not plan to use the Air Rammer for several days,
           remove the batteries.

           Dispose of batteries promptly and properly; do not bury or burn
           them.

Installing the Air Rammer's Batteries

You need two AA batteries to power your Air Rammer.  We recommend alkaline
batteries, such as Radio Shack Cat. No. 23-557.

1.  Set OFF/ON on the bottom of the Air Rammer to OFF.

2.  Use a coin to twist the latch on the battery compartment cover on the
    bottom of the Air Rammer counterclockwise until it stops.  Then slide
    the tip of your finger into the grove next to the latch and pull down
    on the cover to open it.

    Caution:  The battery compartment cover is hinged.  Do not try to
              remove it.

3.  Install the batteries as indicated by the polarity symbols (+ and -)
    marked inside the compartment.

4.  Push the cover back up and twist the latch clockwise to secure it.

Installing the Transmitter's Battery

You need one 9-volt battery to power the transmitter.  We recommend an
alkaline battery, such as Cat. No. 23-553.

1.  Slide the battery compartment cover down to remove it.

2.  Install the battery as indicated by the polarity symbols (+ and -)
    marked inside the compartment.

3.  Replace the cover.  Be sure it snaps into place.


(EB 4/17/96)
(WL 2/29/96)