Radio Controlled Flying Arrow II
(600-4150)                 Operation                  Faxback Doc. # 32024

DRIVING THE FLYING ARROW II

Warning:  Never play with your Flying Arrow II in the street.

1.  Set the Flying Arrow II's OFF/ON switch to ON.

2.  Set HIGH/LOW on the back of the Flying Arrow II to HIGH if the Flying
    Arrow II is on a smooth surface, or to LOW for a rough surface.

    Note:  If you cannot easily move the HIGH/LOW switch, turn the Flying
           Arrow II's back wheels by hand, then try again.

3.  Use the transmitter's control levers to drive.

Important Note:  If the Flying Arrow II runs for a long time or if it is
                 blocked by something, the motor stops for a few minutes
                 to protect it from overheating.  The motor starts again
                 after it cools.

Left Control Lever

    Push forward to move forward.

    Push forward, slide to the right, then forward all the way for turbo
    power.

    Pull backward to move backward.

    Release to stop.

Right Control Lever

    Push left to move left.

    Push right to move right.

    Release to go straight.

4.  When you finish driving the Flying Arrow II, set OFF/ON to OFF.

WHEEL ALIGNMENT

If the Flying Arrow II does not go in a straight line when you release the
right control lever, adjust the wheel alignment control on the front of
the Flying Arrow II.

Slide the lever toward R if the Flying Arrow II is pulling to the left, or
toward L if the Flying Arrow II is pulling to the right.


(EB 4/17/96)
(WL 2/29/96)