Space Patrol Two-Way Walkie Talkie
(600-4024)         Operation                          Faxback Doc. # 32104

1.  Set POWER ON/OFF to ON.  A hiss from the speaker lets you know the
    receiver is working properly.

2.  Press and hold PUSH-TO-TALK and speak into MIC in a normal voice.

    NOTE:  To lock PUSH-TO-TALK so you can talk without holding the switch
           down, push the bottom of the switch in and up.  Slide the top
           of the switch down to release it.

3.  Release PUSH-TO-TALK and listen for the response.

4.  To send Morse Code signals, press PUSH-TO-TALK in and up.  Then press
    the Morse Code button as desired.  Use short presses for dots and long
    presses for dashes.  Refer to the International Morse Code chart on
    the front of the walkie talkie, if necessary.

5.  To receive Morse Code signals, release PUSH-TO-TALK and listen for the
    signals.

6.  When you are finished, set POWER ON/OFF to OFF.

The FCC Wants You to Know

Your Radio Shack Space Patrol Walkie Talkie might cause TV or radio
interference even when it is operating properly.  To determine if your
walkie talkie is causing the interference, turn it off.  If the
interference goes away, the walkie talkie is causing the interference.
Try to eliminate the interference by:

    Moving the walkie talkie away from the receiver

    Contacting your local Radio Shack store for help

If you cannot eliminate the interference, the FCC requires that you stop
using the walkie talkie.


(BR/GLW 04/19/96)