ET-293  Two-Line Amplified Trim-Fone
(430-0622)                 Specifications             Faxback Doc. # 14879

Redial Capacity ................................................. 32 Digits
Power Requirements ............................................. Phone Line
Connector .................................................. USOC Type RJ14
Dialing Rate ................................................ 10 Pulses/Sec
Make/Break Ratio ................................................ 39% / 61%
Inter-Digit Period ....................................... 800 Milliseconds
Touch-Tone Dialing .......................................... Standard DTMF

OPERATING PARAMETERS 

We supply this information to help you answer questions your phone company 
might ask. 

Interface ...................................................... Loop Start
Ringer ............................................ Standard Bridged Ringer
                                                              20-60 Hz Sine
                                                             or Square Wave
                                                   40-130 Volts Ring Signal
Current ........................................................ (Off Hook)
                                                                    20-90mA
Resistance ............................................. 300 Ohm (Off Hook)
                                                          10M Ohm (On Hook)

NOTE:  This phone has Continuous DTMF/Key Following.

Specifications are typical; individual units might vary.  Specifications
are subject to change without notice.


(EB 1/17/96)