Dial-Talk Desktop Talking Phone
(430-0838)                  Installation              Faxback Doc. # 16955

DESK MOUNTING

Modular Telephone Jack   Set to BELL to turn on the ringer.  Set to BELL
to turn off the ringer.

    Switch to (T)ONE or (P)ULSE (rotary) to match the type of service
    you have.

NOTE:  The phone company can charge you for the installation of the
       necessary jack.  The USOC number of the jack to be installed is
       RJ11C.

INSTALLING BATTERIES

NOTES:  The voice announcement feature requires batteries.  But you can 
        still make and receive calls when the batteries are low or dead 
        (if the phone is connected to the line).

        Use fresh batteries of the required size and type.

        Always remove old or weak batteries.

1.  Use a Phillips type screwdriver to remove the screw from the battery 
    compartment cover on the bottom of the phone.

2.  Side off the battery compartment cover.

3.  Insert two AA alkaline batteries (Radio Shack Cat. No. 23-552) into
    the compartment as indicated by the polarity symbols (+ and -) inside 
    the compartment.

4.  Secure the cover with the screw.

5.  Press RESET on the top of the base with the tip of a paper clip or
    a ball-point pen.

NOTE:  Reset the phone each time you replace the batteries.