Caller ID System 360
(430-0963)                 Installation               Faxback Doc. # 18035

INSTALLING/REPLACING THE BATTERY

The module is powered by one 9-volt battery.  For the longest operation,
we recommend you use an alkaline battery (Radio Shack Cat. No. 23-553).
Even if you use the supplied AC adapter, install a battery to keep the
information in the module's memory during power failures.  When the
battery low indicator (BATTERY SYMBOL) appears in the top left corner of
the display or the display dims, replace the battery.

CAUTIONS:  Do not press any buttons after you remove the battery.  Doing
           so can delete all caller information from the module.

           Be sure to keep one fresh 9 volt BATTERY on hand when you
           replace the battery.  You need to replace the battery within
           20 seconds before the display blanks out.  Otherwise, the
           information stored in the module's memory will be lost.

Follow these steps to install the battery.

1.  If you are replacing the battery, unplug the module from the telephone
    line.

2.  Slide off the battery compartment cover.

3.  Remove the old battery, if necessary.

4.  Place the battery in the compartment as shown, following the correct
    polarity (+ and -) as marked inside the compartment.

5.  CAUTION:  Do not force the battery into the compartment.

6.  Replace the cover.


(PH 11/3/95)