TAD-1005 Multi-User Digital Telephone Answering System
(430-0745)                 Installation               Faxback Doc. # 18425

Select a location for the TAD that is near a telephone jack and an AC
outlet and is not in the way of normal activities.

INSTALLING THE BACKUP BATTERY

If the AC power fails or you unplug the TAD, a 9V backup battery (not
supplied) saves the message groups, message counts, and the settings for
the day, time, and security code.  We recommend you use an alkaline
battery, such as Radio Shack Cat. No. 23-553.

1.  Remove the battery compartment cover on the bottom of the TAD by
    removing the screw on the cover's tab, then lifting off the cover.

2.  Snap the battery's contacts firmly to the battery connector, then
    place the battery into the compartment.

3.  Replace the cover.

Replace the battery if LO appears while the AC adapter is properly
connected.

CAUTIONS:  Before you replace the battery, be sure the supplied adapter is
           securely connected to an AC outlet and to the jack on the back
           of the TAD.  Otherwise, you might lose any stored information.

           Always use a fresh battery of the required size and type.

           Dispose of the battery promptly and properly.  Do not bury or
           burn it.

CONNECTING THE AC ADAPTER

CAUTION:  You must use a Class ll AC adapter that supplies 9 volts of
          power, delivers at least 300 milliamps, and has a plug that
          properly fits the TAD's 9-12V DC jack with its center tip set to
          negative.  The supplied adapter meets these specifications. 
          Using an adapter that does not meet these specifications could
          damage the adapter and the TAD.

1.  Insert the barrel plug of the supplied AC adapter into the 9-12V DC
    jack on the back of the TAD.

2.  Plug the other end of the AC adapter into a standard AC outlet.

The TAD initializes itself and counts down from 59 to 0.  The TAD then
beeps and CL (clear) flashes on the display.

NOTE:  Be sure not to press any of the TAD's buttons while you are plugging
       the adapter into the AC outlet.  If you accidentally press a button
       and do not hear the beep, reset the TAD by unplugging the adapter
       from the AC outlet and reinserting it.

CONNECTING TO THE TELEPHONE LINE

1.  Unplug the telephone's modular cord from the modular phone line jack
    and plug it into the TO TEL jack on the back of the TAD.

2.  Plug one end of the supplied modular cord into the TO LINE jack on
    the back of the TAD.

3.  Plug the cord's other end into a modular phone line jack.

NOTE:  If the phone line jack is not a modular jack, you must update the
       wiring.  You can convert the wiring yourself, using jacks and
       adapters available at your local Radio Shack store.  Or, you can
       let the phone company update the wiring for you.

       The phone company will charge you for the installation of necessary
       jacks.

       The USOC number of the jack to be installed is RJ11C.


(PH 11/27/95)