TAD-539 Telephone Answering System (430-0765) Specifications Faxback Doc. # 18743 GENERAL Power Supply (Supplied AC/DC Power Adapter): Input:....................................................120 V AC 60 Hz Output:....................................................9 V DC 500 mA Dimensions (H x W x D):....................3 5/16 x 4 13/16 x 8 9/16 Inches (8.4 x 11.4 x 21.9Cm) Weight:...................................................1.42 lb (0.64 Kg) ANSWERING SYSTEM Telephone Modular Jack:......................................RJ11C or RJ11W Maximum Incoming Message Time:...................................60 Seconds Number of Rings Before Answering: With Messages:.............................................About 2 Times No Messages:...............................................About 4 Times VOX Operating Time without Voice:...........................7 +/- 2 Seconds Tape Speed:.....................................................2.38 cm/sec Remote Control:...........................................DTMF Tone Control Remote Answer-On:..........................After 30 Seconds Continuous Ring Safety Standards:...................................FCC Part 68 and UL-1459 TELEPHONE Pulse Dialing: Dialing Rate:.....................................................10 pps Make Ratio:.........................................................40 % Inter-Digital Pause:..............................................850 mS Access Pause:..........................................Approx. 2 Seconds Tone Dialing:.................................................Standard DTMF Redialing Memory Capacity: Pulse Mode:....................................................32 Digits Tone Mode:.....................................................31 Digits Specifications are typical; individual units may vary. Specifications are subject to change and improvement without notice. ACCESSORIES Message Tape......................................................One MC-30 AC Adapter Wall Mounting Bracket...........................9-Volt DC 500 mA OPERATING PARAMETERS This information is supplied to help you answer questions your phone company might ask. Interface:.......................................................Loop Start Ringer:................Standard Bridged Ringer 16-68 Hz Sine or Square Wave 40-130 Volts Ring Signal Current:............................................20-100 mA DC (Off Hook) Resistance:....................................More Than 10 Mohm (On Hook), 250-300 Ohm (Off Hook) Modular Jack USOC Number:....................................RJ11C or RJ11W (br/SP-1/16/96)