TAD-275 Telephone Answering System
(430-0761)           Remote Control Operation         Faxback Doc. # 19235

While you are away from your home or office, you can use a touch-tone phone
or pocket tone dialer to:

    Set the TAD to answer calls

    Play your messages

    Record a memo

    Erase your messages

REMOTE TURN-ON

You can use any remote phone to set the TAD to answer calls if:

    Power is supplied to the TAD.

    The cassette is loaded.

    The TAD is set to STOP.

To set the TAD to answer calls, dial your phone number and wait about 12-14
rings until the TAD answers.  Then hang up the phone.

NOTE:  Be sure to set STOP/ON to ON when you get home to play back any
       recorded messages.

REMOTE PLAYBACK

To play back your messages from a remote phone, follow these steps.

NOTES:  Friends who know your remote operation security code can follow
        these steps to hear memos you left by remote.

        The TAD resets to answer calls after remote operation. It does not
        rewind and record new messages over the ones you have heard by
        remote.

1.  Dial your phone number.

    The TAD answers on the second ring if there are new messages. If there
    are no new messages, the TAD answers on the forth ring.

    This toll-saver feature saves long-distance charges by indicating if
    you have any new messages. If there are no new messages, you can hang
    up before the TAD answers.

2.  When the outgoing message stops and a beep sounds, enter the remote
    operation security code (found on the bottom of the TAD) within 5
    seconds.  Be sure each button press is at least 1/2 second long.  The
    TAD beeps while the tape is rewinding. If no beep sounds, re-enter the
    code.

    Then the TAD plays back the incoming messages.  At the end of all the
    messages, the TAD beeps four times.

NOTE:  If you hang up while the TAD is playing back the messages, the TAD
       stops and resets to answer the next call if your telephone line has
       CPC service.  Otherwise, the TAD might not recognize that you hung
       up.  If someone calls while the TAD continues to play the messages,
       the caller hears a busy signal.

To replay the messages, wait about 8 seconds.  After a single beep, enter
the remote code.

Saving the Messages

If you want to save the messages, simply hang up the phone during or after
playback of the messages.

Erasing the Messages

If you want to erase the messages after playback, enter the remote
operation security code within 8 seconds after the four short beeps at the
end of all the messages.  After the TAD beeps, hang up the phone.

NOTE:  After you erase messages, you cannot recover them by pressing
       SAVE/FAST-F.

Recording a Remote Memo

You can record a remote memo for your family or friends who know the remote
operation security code.

After the four beeps at the end of all the messages, wait 8 seconds.  After
you hear a single beep, leave a message up to 60 seconds long, then hang up
the phone.


(EB 1/9/96)