ET-293  Two-Line Amplified Trim-Fone
(430-0622)                 Preparation                Faxback Doc. # 19488

SETTING THE TONE/PULSE SWITCH

Set TONE/PULSE for the type of service you have.  If you are not sure which
type of service you have, follow these steps.

1.  Set TONE/PULSE to TONE.

2.  Press LINE 1.

3.  Lift the handset and listen for a dial tone.

4.  Press any number other than 0.

    If the dial tone stops, you have touch-tone service on that line.  If
    the dial tone continues, you have pulse service.

5.  Press LINE 2, and repeat Steps 3 and 4.

6.  If you have pulse service on either line, set TONE/PULSE to PULSE.  If
    you have tone service, leave TONE/PULSE set to TONE.

NOTE:  The # button has no function in the pulse mode.

SETTING THE RINGER HI/LO OFF SWITCH

Set the volume for each line's ringer. Set HI/LO/OFF to HI in a noisy room,
such as the kitchen.  Set HI/LO/OFF to LO in a quiet room, such as a
bedroom.

If you do not want a ringer to sound, set HI/LO/OFF to OFF.  You can still
answer the phone if you hear an extension phone ringing, and you can still
make calls.  The green indicator flashes when you receive a call.

CONFIRMING LINE NUMBERS

To determine the phone number for each line, press LINE 1, lift the
handset, and dial one of the phone numbers.

If the green indicator for Line 2 flashes, the number you dialed is for
Line 2.  If you hear a busy signal, the number is for Line 1.

Write the phone numbers in the spaces provided on the handset's cradle.

NOTE:  If you have Rollover (Hunt), ask someone to call one of the phone
       numbers from a third phone line and note which green indicator
       flashes.


(EB 1/17/96)