AFX-250 Automatic Fax Switch  
(430-1244)                 Quick Start                Faxback Doc. # 19608

PROGRAMMING QUICK START

This section provides a quick reference for experienced users to start  
programming the AFX-250.  See the "Quick Start Command Chart" for a list of
all default settings and remote commands.  

Programming from an Extension Phone

1.  Pick up any phone on the same line as the AFX-250.

2.  Enter 1, *, then your 2-digit access code (preset to 99).

3.  Enter a remote command.

4.  Hang up the phone.

NOTE:  To program another feature, repeat these steps.

Programming from a Remote Phone

1.  Dial you phone number.

2.  After the TAD or fax switch answers, enter 1, *, then your 2-digit
    access code (preset to 99).

3.  Enter a remote command within 10 seconds.

4.  Hang up the phone.

NOTE:  To program another feature, repeat these steps.

Command                           Default     You     Number of Times the  
                                  Setting    Press       AFX-250 Beeps  

Change the Access Code (New         99      * 1, New          2  
code can be from 00-99)                       Code  

Change the Ring Number Setting      5         * 2,            2  
(Ring number can be from 1-7)                 Ring  
                                             Number  

Turn On/Off the FAX jack            On        * 5            2=On  
                                                             3=Off  

Turn On/Off the TAD jack            On        * 6            2=On  
                                                             3=Off  

Turn On/Off the Fax Password        Off       * 7            2=On  
(The preset password, if on,                                 3=Off  
is 1 # 9 9)  


(EB 1/19/96)