TandyFax 1500  (430-1215)      Information Codes        Faxback Doc. # 8915

When something unusual occurs, the display shows one of the information
codes below.  These help you identify the problem.

Information............Meaning..............................Remedy
Code
___________________________________________________________________________

001/002/.........Recording paper jam...................Remove jammed paper.
003/004

010..............No recording paper.........................Load the paper.

020..............Thermal recording head.........Open the receiving unit for
                 temperature is too high............a few minutes to permit
                                                                   cooling.

030..............Document is not set properly.......1.  Reload the document
                 properly.........................................properly.
                                                    2. Remove document jam.
                                                 3. Adjust document feeder.

031..............Document is jammed or..........Open the transmitting guide
                 document length exceeds...........and remove the document.
                 39 1/2" inches....................Then reset the document.

039..............You pressed STANDBY/STOP...........Press STANDBY/STOP if a
                 while sending or copying..........document already entered
                 documents and more than..........the feeder and remove the
                 one page remain on the............documents on the feeder.
                 feeder..................Reload the document and try again.

060..............Door is open.....................Close the receiver cover.

400..............During initial communication,......1. Check with the other
                 receiving station did not...........................party.
                 respond or communication............2. Reload the document
                 error occured...............................and try again.

402/404/405......During initial communication,......Reload the document and
                 failure in communication........................try again.
                 occurred.

403..............No polling capability at the.........Ask other side to set
                 other side.........................machine to "POLLED=ON."

407..............No confirmation from the............Wait a few minutes and
                 receiving station for the......................send again.
                 previous page sent.

408/409..........Other side confirmation of..........Wait a few minutes and
                 previous  page is illegible................transmit again.

411/414..........Polling password does not match....Check polling password.

412..............No data from the...............Check with the other party.
                 transmitting side.

415..............Polling function is............Inform the other party that
                 incompatible....................your machine does not have
                                          the polling transmission feature.

416/417/418/.....Received data has too many.....Check with the other party.
419/490..........errors.

420/421..........Machine went into receiving....Check with the other party.
                 mode, but no command.
                 from the transmitting side.

422..............Interface is compatible........Check with the other party.

434/459/493/.....Communication error............Check with the other party.
    494..........occurred while receiving.

451/495..........Telephone line disconnected....Check with the other party.

630..............Redialing was not..............Reload the document and try
                 successful because of a.............................again.
                 busy line or no response.

633..............The sixth redial attempt for.....Restore the document into
                 memory/multistation..................memory and try again.
                 transmission failed.*

870..............Memory overflow.....................If this happens during
                                         memory reception, reload recording
                                       paper. If this happens during memory
                                     transmission or multiple copy, send or
                                            copy the document in two parts.

(smc-03/03/94)