Micronta Walk & Jog Mate
(630-0682)                 Operation                  Faxback Doc. # 15899

This unit does not have an off button.  It stays on all the time.
Replace the battery when it gets low.

1.  Set the mode switch to either Steps or Distance.  The corresponding
    symbol appears on the display.

2.  Reset the display to 0 steps or 0.00 mi by pressing [START].

3.  Slip the Walk & Jog Mate's belt clip over your belt.  Then, slide the
    pedometer halfway between the middle front of your body and your side,
    as shown.  Do not place your Walk & Jog Mate directly in front of you
    or at your side.

NOTE:  To see the distance in steps or  miles, push the mode switch to the
appropriate setting.

Your Walk & Jog Mate might not work properly under these conditions:

    When you are not wearing the it correctly.

    When you skip or shuffle.

    When you climb a steep hill or take short, quick steps down a hill.

    If you wear it in a vehicle and encounter a stretch of rough road.


(YO/EB 5/14/96)