LED Easy Set Alarm  (630-0750)        Power            Faxback Doc. # 16334
Clock

CONNECTING POWER

To power the alarm clock, plug the clock's power cord into a standard AC
outlet.

When you first plug in the clock, the display flashes.  It stops flashing
when you set the time.  The display also flashes if AC power is interrupted
and a back battery is not installed.

INSTALLING A BACK-UP BATTERY

Install a 9-volt battery (not supplied) in your alarm clock for backup
power.  We recommend an alkaline battery, such as Radio Shack Cat. No.
23-553.

NOTE:  To prevent unnecessary drain on the battery, connect the clock to a
       standard AC outlet before you install the battery.

1.  Slide the battery compartment cover in the direction of the arrow to
    open it.

2.  Snap the battery into the terminals and place it inside the
    compartment.

    CAUTION:  Use only a battery of the required size and type.

3.  Replace the cover.

NOTES:  If you have installed a back-up battery, the display turns off
        during a power failure.  However, the clock continues to run for
        about 8 hours and the alarm sounds at the preset alarm time.

        If the entire display flashes when power is restored after a power
        failure, replace the battery and reset the clock.

        When the BATTERY SENTINEL indicator on the right side of the
        display lights, replace the battery.


(ALL-08/04/95)