LED Easy Set Alarm  (630-0750)        Operation        Faxback Doc. # 16335
Clock

SETTING THE TIME

1.  Set SET/RUN on the bottom of the clock to SET.

    NOTE:  The PM indicator lights when the clock displays a PM hour.

2.  To set the hour, turn HR/MIN toward HR.  Turn HR/MIN rapidly to quickly
    advance the hours.

3.  To set the minutes, turn HR/MIN toward MIN.  Turn HR/MIN rapidly to
    quickly advance the minutes.

4.  Set SET/RUN to RUN when the correct time is displayed.

SETTING THE ALARM

1.  Press and hold down ALARM SET/SNOOZE.  The current alarm time appears
    on the display.

    NOTE:  If the BATTERY SENTINEL indicator lights when you press ALARM
           SET/SNOOZE, the back-up battery is getting low.

2.  While holding down ALARM SET/SNOOZE, follow Steps 2-3 under "Setting
    the Time" to set the alarm time.

3.  When the correct alarm time is displayed, release ALARM SET/SNOOZE.

NOTE:  Press ALARM SET/SNOOZE to view the alarm time at any time.

USING THE ALARM

Once you set the alarm time, set OFF/ALARM/ON on the bottom of the clock to
ON to turn on the alarm so it will sound at the set time.  The ALARM
indicator in the display's upper left corner lights.  At the alarm time you
set, the alarm sounds for about 2 hours, or until you turn it off.

When the alarm sounds, you can press ALARM OFF to silence the alarm.  It
will sound at the same time 24 hours later.

Or, set OFF/ALARM/ON to OFF to turn off the alarm so it will not sound
again 24 hours later.

USING SNOOZE

To temporarily turn off the alarm for about 9 minutes, press ALARM
SET/SNOOZE while the alarm sounds.  The alarm turns off and sounds again in
about 9 minutes.

You can press ALARM SET/SNOOZE to repeat the alarm on/off cycle for a total
of about 2 hours.  After the 2-hour cycle, the clock resets to sound the
alarm again 24 hours later.


(ALL-08/04/95)