Casio Watch (LQ139-A1) (630-5245) Specifications Faxback Doc. # 18411 CASIO Module No. 310 317 319 323 329 331 332 337 339 340 341 351 359 361 369 371 381 391 701 703 705 706 1300 HAND (Ver.R) ES To set time (1) Pull the crown out when the second hand at 12 o'clock position and the second hand stops. (2) Set the hands by turning the crown. (3) In accordance with a time signal, push the crown in. Module No. Accuracy at normal Battery type Battery life temperature 310/341 +/- 20 seconds per month GR-927/SR927SW Approx 5 years 317/706 +/- 20 seconds per month No. 371,SR920SW Approx 3 years 319/340/361 +/- 20 seconds per month No. 377,SR626SW Approx 2 years 323 +/- 15 seconds per month No. 371,SR920SW Approx 18 months 329/359 +/- 20 seconds per month SR527SW Approx 2 years 331 +/- 15 seconds per month No. 379,SR521SW Approx 2 years 332 +/- 15 seconds per month No. 371,SR920SW Approx 3 years 337/339 +/- 20 seconds per month No. SR621SW Approx 18 months 351 +/- 15 seconds per month No. 317,SR516SW Approx 2 years 369/701 +/- 30 seconds per month SR527SW Approx 2 years 371 +/- 20 seconds per month No. 399,SR927SW Approx 3 years 381 +/- 20 seconds per month No. 377,SR626SW Approx 3 years 391 +/- 30 seconds per month No. 377,SR626SW Approx 3 years 703 +/- 20 seconds per month SR521SW Approx 2 years 705/1300 +/- 20 seconds per month SR621SW Approx 2 years Case Splashes, Swimming, Snorkeling, Scuba *Rank Designation rain, etc. Car-washing, etc. Diving, etc. diving I - No No No No ___________________________________________________________________________ II WATER Yes No No No RESISTANT ___________________________________________________________________________ III 50 M WATER Yes Yes No No RESISTANT ___________________________________________________________________________ IV 100 M WATER Yes Yes Yes No RESISTANT ___________________________________________________________________________ 200 M WATER RESISTANT V 300 M WATER Yes Yes Yes Yes RESISTANT ___________________________________________________________________________ NOTES I Not water-resistant. II Do not operate buttons or pull out the crown while the watch is under water. III Do not operate buttons or pull out the crown while the watch is under water. IV Button operation underwater is allowed, but do not operate recessed buttons and do not pull out the crown while the watch is under water. If watch is exposed to salt water, wash thoroughly and wipe dry. V Usable while scuba diving (except at depths that require helium-oxygen gas). Your water-resistant watch has been tested in accordance with the International Organization for Standardization regulations ISO228l and FTC (USA) "GUIDE FOR THE WATCH INDUSTRY", Guide 5. Some water-resistant watches feature leather bands. Do not wear such a model during swimming or any other activity during which the band is immersed in water. CARE OF YOUR WATCH Never try to open the case or remove its back cover. You should have the rubber seal that keeps out water and dust replaced every 2 to 3 years. For watch with the elapsed time bezel Rotate the elapsed time bezel to align the SYMBOL mark with the minute hand. After certain amount of time elapsed, read the graduation on the elapsed time bezel which the minute hand points to. The elapsed time is indicated. Read this important information first Battery The battery loaded at the factory discharges during shipment and storage. At the first sign of low power (slow timing), have the battery replaced by your dealer or a CASIO distributor. Water Resistance This watch will withstand the ingress of water at the static pressure indicated on its case (50, 100, or 200 meters) and immersion in salt water at the depth indicated. Note, however, that dynamic pressure generated by movement underwater is greater than static pressure. Note the following: Should moisture appear inside the watch, have it checked immediately by your dealer or CASIO distributor. Avoid exposing the watch to temperature extremes. Though the watch is designed to withstand normal use, you should avoid rough use or dropping the watch. Do not fasten the band too tightly. You should be able to insert your finger between your band and your wrist. To clean the watch and band, use a dry soft cloth or a soft cloth moistened in a solution of water and a mild neutral detergent. Never use volatile agents (such as benzine, thinner, spray cleaners, etc.) Store your watch in a dry place when you are not using it. Avoid exposing the watch in a dry place when you are not using it. Avoid exposing the watch to gasoline, cleaning solvents, aerosol sprays, adhesive agents, paint, etc.) Chemical reactions with such agents will destroy seals, case and finish. Some models feature silk screen printing on their bands. Be careful when cleaning such bands so that you do not rub on the printed designs too hard. For watches equipped with resin bands You may notice a whitish powdery substance on the band. This substances will not harm your skin or clothing, and can be removed by simply wiping it with a cloth. For watches equipped with florescent bands and cases Long-term exposure to direct sunlight can cause fluorescent coloring to fade. Long-term contact with moisture can cause fluorescent coloring to fade. Be sure to wipe all moisture from the surface of the watch as soon as possible. Long-term contact with any other surface while wet can cause discoloration of fluorescent colors. Be sure to keep moisture from fluorescent surfaces and avoid contact with other surfaces. Strongly rubbing a printed fluorescent surface with another surface can cause the color of the printing to transfer to the other surface. (PH 11/8/95)