Casio Watch (LQ139-A1)
(630-5245)                 Replacing Batteries        Faxback Doc. # 18412

[How to replace the battery]    CAUTION: Battery replacement should
                                         not be attempted without use
                                         of the correct tools.

1.  Check the type of back cover

    Screw-in      Screwed      Snap-on      Snap-on      Snap-on
    type          type         type (A)     type (B)     type (C)

2.  Removing the back cover.  Place the watch on soft material, like
    buckskin, and hold it firmly.

  With the          Using a       Insert        Fit Case      Insert Opener
  Adjustable        screwdriver,  Opener A      Opener B      B into a gap
  Case Opener,      remove the    in the        into the      between the
  turn the          screws from   recess and    notch and     two hooks,
  back cover        the back      move from     pry open      and pry open
  counterclockwise. cover.        side to       the back      the back
                                  make a gap    cover.        cover.  Avoid
                                  between the                 inserting the
                                  cover and                  case opener at
                                  the case.                   the hook 
                                  Then use the                position or
                                  Opener to pry               the case may
                                  off the cover.              be damaged.

BATTERY LIFE:  Battery life is calculated from when the battery is loaded
               at the factory.  At first sign of power fade (dim display),
               have battery replaced at dealer or CASIO distributor.

3.  Replacing the battery.

Screw Type: Using a screwdriver remove screw(s) from the battery holder.

Hook Type:  Use a thin flat blade jeweler's screwdriver to pull hook on
            one side of the battery holder and remove the holder.  Then
            replace dead battery(s) and attach the battery holder.

CAUTION:  Avoid touching the contact (-) of the battery.

          Never hold the contacts with metallic tweezers.

          Work carefully so that the components inside the watch do not
          pop up.

4.  AC (AC CLEAR)

    As shown right, touch the AC contact and the battery (+) side with
    metallic tweezers.  Contact should be about 2 seconds.

IMPORTANT:  (a)  Contacting AC (ALL CLEAR) is necessary, when a new
                 battery has been put in, because the memories/counters
                 may cause erratic displays.

            (b)  On some models, pushing the light button will turn on the
                 display.

5.  Fitting the back cover.

    Using the           Tighten the screws,      Place the watch   
    Adjustable Case     using a screwdriver.     on a hand press   
    Opener, tighten                              and push the      
    the back cover.                              back cover in
                                                 gently.
    
    Hold the watch
    horizontally
    and snap-fit
    the back cover.


(PH 11/8/95)