Jumbo-LED Digital Alarm Clock
(630-0749)                 Preparation                Faxback Doc. # 18507

Connecting Power

To power the alarm clock, plug the clock's power cord into any standard AC
outlet.  The display flashes until you set the time.

Installing the Battery

For backup power, install a 9-volt battery in the alarm clock.  We
recommend an alkaline battery, such as Radio Shack Cat. No. 23-553.

NOTE:  To prevent any unnecessary drain on the battery, make sure you
       connect the alarm to an AC power outlet before you install the
       battery.

1.  Push the battery compartment cover's tab and lift off the cover in the
    direction of the arrow.

2.  Snap a fresh battery into the terminals and place it inside the
    compartment.

    CAUTION:  Use only a battery of the required size and type.

3.  Replace the cover.

NOTES:  If a backup battery is installed, the display turns off during a
        power failure.  But, the clock continues to run for about 8 hours
        and the alarm sounds at the preset alarm time.  When power is
        restored, the clock should keep accurate time, depending on the
        battery strength.

        If the display flashes when power is restored after a power
        failure, replace the battery.

        When the BATTERY SENTINEL indicator lights, replace the battery.

Using the Dimmer

Set DIMMER HI/LO to the desired display brightness.


(JC  11/2/95)