Jumbo-LED Digital Alarm Clock
(630-0796)                 Preparation                Faxback Doc. # 19523

Connecting Power

To power the alarm clock, plug the clock's power cord into any standard AC
outlet.  The display flashes until you set the time (see "Setting the
Time", Faxback Doc. # 19522).

Installing a Backup Battery

For backup power, install a 9-volt battery in your alarm clock.  We
recommend an alkaline battery, such as Radio Shack Cat. No. 23-553.

NOTE:  To prevent any unnecessary drain on the battery, make sure you
       connect the alarm to an AC power outlet before you install the
       battery.

1.  Push the arrow on the battery compartment cover and lift off the cover.

2.  Snap a fresh battery into the terminals and place it inside the
    compartment.

    CAUTION:  Use only a fresh battery of the required size and type.

3.  Replace the cover.

NOTES:  If a backup battery is installed, the display turns off during a
        power failure.  But, the clock continues to run for about 8 hours
        and the alarm sounds at the preset alarm time. If the backup
        battery's strength was adequate, the clock's time will still be
        accurate after AC power is restored.

        If the display flashes when power is restored after a power
        failure, replace the battery.

        When the BATTERY SENTINEL indicator lights, replace the battery.

Using the Dimmer

Set DIMMER HI/LOW to the desired display brightness.


(EB 1/19/96)