EC-367 Personal Telephone Directory
(650-0881)                 Preparation                Faxback Doc. # 31525

PERFORM THE RESET OPERATION BEFORE USING THE UNIT FOR THE FIRST TIME

Follow these steps to reset the unit.

IMPORTANT!  Pressing the RESET also clears all data currently stored in the
unit's memory.

1.  Use a thin, pointed object (such as a straightened paper clip) to press
    RESET on the front of the unit.  RESET? appears on the display.

2.  Press SET.  RESET! appears for about one second, followed by INPUT
    WORD!.  This indicates that all data has been cleared from memory.

    If you want to abort the reset operation in the above step, press AC.

AUTO POWER OFF

The EC-367 saves battery power by automatically switching off after about 6
minutes if no key is pressed.  To turn it back on, press ON.

TO ADJUST DISPLAY CONTRAST

1.  Press AC to enter the Calculator Mode.

2.  Press /\ to increase contrast (making the figures on the display
    darker) or \/ to decrease contrast (making the figures lighter).

IMPORTANT PRECAUTIONS

    Never allow this unit to be exposed to direct flame.

    Avoid use and storage under temperature extremes.  Do not place the
    unit in direct sunlight, near windows, near a heater, or anywhere else
    where it is subject to high heat.  Heat can lead to discoloration or
    warping of the case, and can even damage internal circuitry.

    Under very low temperatures, display response may slow down or fail
    entirely.  This condition is temporary and operation should return
    under normal temperatures.

    Avoid use and storage in areas subject to excessive moisture, dirt, and
    dust.  Direct contact with liquids and dust can damage internal
    circuitry.

    Avoid dropping the unit and otherwise subjecting it to severe impact.

    Never bend or twist the case.

    Never try to take the unit apart.

    Do not use a pen, pencil, or other sharp object to press keys.

    To clean the exterior of the unit, wipe it off with a soft cloth
    dampened in a weak solution of a mild detergent and water.  Be sure to
    wring out any excess moisture from the cloth before wiping off the
    unit.  Never use benzene, thinner, or any other volatile agent to clean
    the unit.  Doing so can remove the figures printed on the case or
    otherwise damage the case finish.


(EB 3/26/96)