LCD Desktop Time and Weather Barometer
(630-0856)                 Preparation                Faxback Doc. # 32746

INSTALLING BATTERIES

Your barometer is powered by four AAA batteries (not included).  For best
performance, we recommend alkaline batteries, such as RadioShack Cat. No.
23-555.

1.  Lift up the desktop stand as shown.  Then remove the battery
    compartment cover by sliding it in the direction of the arrow marked on
    the cover.

2.  Install four batteries as indicated by the polarity symbols (+ and -)
    marked inside the battery compartment.

    When you first install the batteries, the display shows 12:00 AM, the
    current temperature, the partly cloudy weather illustration, and the
    barometric pressure trend charts.

3.  Replace the battery compartment cover.

NOTE:  It takes about 24 hours for the barometer to store the pressure
       readings, so weather forecasting does not work properly until 24
       hours have passed.

When BATT appears in the bottom left corner of display, it is time to
replace the batteries.

CAUTION:  Always replace old or weak batteries.  They can leak chemicals
          that can damage the barometer.

MOUNTING THE BAROMETER

To place your barometer on a desktop, pull out its stand.

You can also mount your barometer on a wall using a screw (not supplied)
that fits into the key-hole slot.

1.  Insert the screw into the wall until the head extends about 1/8 inch
    from the wall.

2.  Position the key-hole slot over the screw head and slide the barometer
    down to secure it in place.


(RMF/all-05/14/96)