Jumbo LCD Alarm Clock
(630-0739)                 Operation                  Faxback Doc. # 34041

SETTING THE CURRENT TIME

1.  Lift the control panel cover from the bottom front of the clock.

2.  Set TIME SET/LOCK/ALARM SET to TIME SET.  The large time display
    flashes.

3.  Repeatedly press /\ or \/ to set the time forward or backward.  AM or
    PM appears to the left of the time.

    NOTE:  If you hold /\ or \/ for about 3 seconds, the time changes
           rapidly.

4.  Set TIME SET/LOCK/ALARM SET to LOCK.  The time stops flashing.

SETTING THE ALARM TIME

1.  Set TIME SET/LOCK/ALARM SET to ALARM SET.  The small alarm time display
    (on the left) flashes.

2.  Repeatedly press /\ or \/ to set the alarm time forward or backward.

    AM or PM appears above the alarm time.

    NOTE:  If you hold /\ or \/ for about 3 seconds, the alarm time changes
           rapidly.

3.  Set TIME SET/LOCK/ALARM SET to LOCK.  The alarm time stops flashing.

USING THE ALARM

Set ON/ALARM/OFF to ON to turn on the alarm.  The ALARM BELL appears on the
small alarm time display.

At the alarm time, the alarm begins sounding low-volume beeps.  Every 9
seconds, the alarm's pattern changes and the volume increases.

After 1 minute, the alarm automatically turns off.  To silence the alarm
sooner, set ON/ALARM/OFF to OFF.

USING SNOOZE

When the alarm sounds, you can press LIGHT/SNOOZE on the lower right corner
of the display to silence the alarm for about 5 minutes.

You can continue pressing LIGHT/SNOOZE until you set ON/ALARM/OFF to OFF.

The alarm sounds again at the preset time the next day.

USING THE LIGHT

Press LIGHT/SNOOZE to light the display for about 3 seconds.

USING THE STAND

To use the control panel cover as a stand, pull the cover over the back of
the clock until it snaps into place.


(YO/EB 6/20/96)