Water Resistant LCD Alarm Watch
(630-5064)                   Operation                Faxback Doc. # 34165


You can control and set all functions of your Micronta watch by pressing
the two buttons on its side.  Follow the steps below in sequence and begin
with the time displayed.

SETTING THE TIME AND DATE

NOTE:  S1 is the ALARM TIME/DATE/SEC button (this is the top one).  S2 is
       the DATE/SEC select button (the bottom one)

1.  Press and hold S2 until the seconds digits flash.  Release it and
    press S1. The seconds reset to 00

2.  Press S2. The hours digits flash and A for AM or P for PM appears.
    Then press S1 to set the correct hour.

NOTE:   Be sure to press S1 until A or P is correctly set.  Morning or
        evening time affects the time, and alarm and calendar date
        operation.

3.  Press S2.  The first minute digit flashes.  Then, press S1.  Continue
    pressing S1 to set the correct first minute digit.

4.  Press S2.  The second minute digit flashes.  Then, press S1 to set the
    correct second minute digit.

5.  Press S2.  The month digit flashes and the day digits light steadily.
    Then press S1 to set the correct month.

6.  Press S2.  The DAY digits flash.  Then, press S1 to set the correct
    day.

7.  Press S2.   The display shows the current time.


(IR-08/07/96)