8-Zone Alarm System  (490-0485)     System Defaults    Faxback Doc. # 14901

SYSTEM DEFAULTS

Master Code:      Used to arm or disarm system as well as access
                  programmable
Default- 1 2 3 4  system parameters.

User Codes (6):   Used to arm and disarm system only.
Default- 0 0 0 0

Ambush Code:      Used when an optional bus interface dialer.  This code
Default- 0 0 0 0  simulates a system disarm locally while actually dialing
                  the monitoring service and transmitting a distress
                  signal.  If no dialer is present, this code will simply
                  arm and disarm the system.

  Note:  The default user codes (0 0 0 0) are null codes and will not
         disarm or arm the system.  The user codes must be reprogrammed to
         become valid.

         The user will not be allowed to program the master code (0 0 0 0).
         User codes can be disabled by programming (0 0 0 0).

Away Mode:       Determines which zones are active in AWAY armed mode.
Default - Zones  
1 through 7 are
assigned.

Home Mode:       Determines which zones are active in HOME armed mode.
Default -Zones
1 through 5 are
assigned.

Delay Mode:      Determines which zones are delayed in faulted while in
                 AWAY
Default -Zones   mode.  Default delay time for these zones is 30 seconds.
1,2,3,6 and 7
are assigned

Day Mode:        Determines which zones are active in DAY mode.
Default-Zones
1 through 3 are
assigned.


(SP/all-04/25/95)