Door Alarm and  (490-0422A)        Battery             Faxback Doc. # 15625
Entry Chime

The alarm requires one 9-volt battery for power.  We recommend an alkaline
battery, such as Cat. No. 23-553.

1.  Set the mode switch to OFF.

2.  Use a Phillips screwdriver to remove the two screws on the bottom of
    the alarm.

3.  Press your fingers into the holes on the back cover and remove the
    cover.

4.  Snap the battery into the connector's terminals.

NOTE: If the alarm sounds, enter the preset factory security code, 1234,
      to silence it (see "Setting the Security Code").

REPLACING THE BATTERY

If one of the following conditions occurs, replace the battery:

    the chimes' or alarm's sound becomes weak

    the red indicator does not light

    the alarm does not work at all when the door opens

    the alarm sounds a steady tone, and you cannot stop it by entering the
    security code

    the alarm stops sounding before you enter the code or before 90 seconds

If the alarm does not respond after you replace the battery, remove the
battery and re-install it.  Each time you remove the battery, the security
code resets to 1234.


(llg/all-06/13/95)