Door Alarm and  (490-0422A)       Installation         Faxback Doc. # 15626
Entry Chime

INSTALLING THE ALARM

You must mount the alarm and magnet so the magnet rests with its arrow
pointing toward one of the alarm's markings for proper alignment.  Choose
a location that lets you install the magnet on a door or window and the
alarm immediately next to it on the frame, or vice versa.  The distance
between the alarm and magnet must be no more than 5/16-inch.

Use the supplied screws or the supplied adhesive tape and follow these
steps to mount the alarm and magnet.

1.  Remove the two screws on the bottom of the alarm and remove the back
    cover, if necessary.

2.  Use three of the five supplied long screws or the two larger pieces of
    the supplied adhesive tape to mount the back cover.

    NOTE: You might need to drill starter holes for the screws.  Use the
          back cover as a template.

3.  Slide the alarm onto the back cover.

4.  Replace the two screws on the bottom of the alarm.

5.  Use the two remaining long screws or the smaller pieces of the
    supplied adhesive tape to mount the magnet so its arrow points toward
    one of the markings on either side of the alarm.

CHECKING THE INSTALLATION

Set the alarm's mode switch to Chime and open the door.  You should hear
the electronic chimes.  If not, readjust the position of the magnet.

SETTING THE SECURITY CODE

You can set your own four-digit alarm security code.

NOTES:  The alarm's security code is preset to 1234 at the factory.  Be
        sure you use a different security code.

        You must enter all four numbers within 15 seconds, or the red
        indicator turns off and the alarm exits the procedure and resets to
        the previous security code.

        If you remove the battery, the security code resets to 1234.

Follow these steps to set your own security code.

1.  Press CODE.  The red indicator lights.

2.  Enter the current security code.  The red indicator flashes.

    NOTE: If this is the first time you are setting the code after
          installing or replacing the battery, enter 1234.

3.  Enter the desired four-digit code.  The red indicator lights steadily.

4.  Press CODE within 5 seconds.  The red indicator turns off.

NOTE: If you do not press CODE within 5 seconds, the red indicator turns
      off and the alarm exits the procedure and resets to the previous
      security code.

CHECKING THE SECURITY CODE

Follow these steps to check your security code.

1.  Set the mode switch to DELAY and open the door.

2.  Enter the security code within 8 seconds.  The red indicator lights
    briefly.

If the indicator does not light or the alarm sounds, you entered the wrong
security code.  Reset the security code.


(llg/all-06/13/95)