Infrared Alarm System
(490-0330)                 Operation                  Faxback Doc. # 17265

ARMING AND DISARMING

To arm the system, enter your 4 digit security code.  The system beeps when
you enter the fourth digit. It then enters the 30-second exit delay. ARMED
flashes every 5 seconds during the exit delay and when the system is armed.

When you enter the protected area with the system armed, it sounds a long
beep.

To disarm the system, enter your 4 digit security code. The alarm beeps 
twice when you enter the correct code. If you do not enter the correct 
security code within 30 seconds of entering the protected area, the alarm 
sounds.

If you enter an incorrect code, the alarm sounds four beeps. If the alarm 
is sounding, press * to clear the error, then enter the correct code.

NOTE:  If your security code does not arm or disarm the system, try the 
       default code ( 1 2 3 4 ). If the system still does not arm or
       disarm, remove and reinstall the batteries. This resets the security
       code to 1 2 3 4.  If the system is armed the alarm will sound when
       you remove it from the wall. 

What Beeps Mean

Number of beeps                            Meaning

       1                               Code accepted, system is armed.
       2                               Code accepted, system is disarmed.
       4                               Incorrect code entered.
       1 (long BEEP)                   System armed, entry delay period.

USING THE PANIC (EMERGENCY) ALARM

You can immediately sound the alarm by pressing * and # at the same time.
The alarm sounds immediately for 5 minutes. The system is armed after the
alarm stops.

NOTE:  You can silence the alarm by entering your security code.

TAMPER SWITCH

If the system is removed from the wall when it is armed, the tamper 
switch trips the alarm and it immediately sounds continuously (for 5 min). 
To stop the alarm sooner, enter your security code.

TESTING THE SYSTEM

We recommend that you test your alarm at least once a month.

Entry/Exit Delay and Coverage Test

1.  Arm the system.

2.  After the 30-second exit delay, walk around the protected area and 
    watch the ARMED indicator.  When the system detects motion, the
    indicator flashes, the system sounds a long beep, and the 30-second
    entry delay begins.

3.  After the entry delay, the alarm sounds for 5 minutes.  To stop the
    alarm sooner, enter your security code.

To change the coverage area, see "Setting the Coverage Area".

Panic Alarm Test

Press * and # at the same time.  The alarm sounds.  If the system is
disarmed, this also arms the system.  Enter your security code to stop the
alarm and disarm the system.

Tamper Alarm Test

1.  Arm the system.

2.  Remove the system from the wall.

3.  The alarm immediately sounds. To stop the alarm, enter your security 
    code.

4.  Remount the system.