Infrared Alarm System
(490-0330)                  Preparation               Faxback Doc. # 17266

INSTALLING/REPLACING BATTERIES

1.  If the system is installed, remove it from the wall.

2.  Remove the screw from the battery compartment cover with a Phillips
    head screwdriver and lift off the cover.

3.  Remove old batteries and install fresh ones, following the polarity
    symbols (+ and -) marked in the compartment.

4.  Close the cover and tighten the screw.

NOTE:  Replacing batteries resets the security code to 1 2 3 4.

Low Battery Indication

When battery is low, LOW BATT flashes every 10 seconds. Immediately replace
all the batteries with fresh ones.

SETTING THE SECURITY CODE

You use your 4 digit security code to arm the system.  The default code is
1 2 3 4. Follow these steps to program a new security code.

1.  Disarm the system (the ARMED indicator should not be flashing) by 
    entering the current security code, if necessary.

2.  Press PROG.

3.  Enter the current security code.

4.  Enter your new security code.

5.  Press PROG.

After you change the security code, confirm it is correct by arming and
disarming the system. See "Arming and Disarming" (Faxback Doc. # 17265).

If You Forget Your Security Code

You can reset the code to the factory default (1 2 3 4) by removing the 
batteries.

NOTE:  If the system is armed, the tamper alarm sounds immediately when you
       remove it from the wall.