Remote Control Talking Alarm System
(490-0740)                 Operation                  Faxback Doc. # 17327

TRIGGERING THE ALARM

The alarm's siren is triggered in these ways:

    When the system is automatically armed and a door is opened after
    the 30-second delay period, the alarm sounds after a 12-second
    entry delay.

    If the door is opened and the system was remotely armed, the alarm
    sounds instantly.

    If ARM and DISARM are pressed at the same time on the transmitter,
    the panic alarm sounds instantly.

    If the motion sensor detects vibration, the system announces a
    warning message, "This vehicle is equipped with an alarm, please
    step back."

    If the motion sensor detects vibration again within 30 seconds
    after the warning, the siren sounds after 12 seconds (if the
    system was automatically armed) or instantly (if the system was
    remotely armed).

The alarm sounds for 90 seconds or until you disarm the system.

After the alarm has been triggered and the siren has sounded for 90
seconds, if the motion sensor detects vibration again with 30 seconds, the
siren sounds after a 12-second entry delay (if the system was automatically
armed) or instantly (if the system was remotely armed); if vibration is
detected after 30 seconds, the system announces, "This vehicle is equipped
with an alarm, please step back."

NOTE:  If you have a cellular telephone or other mobile radio equipment,
       turn it off before you leave your vehicle.  Otherwise, your alarm
       can detect the power drain and sound the alarm.

ARMING THE SYSTEM

Automatic Arming

The system automatically arms 30 seconds after you turn off the ignition.
The red indicator flashes rapidly during the exit delay and lights steadily
when the system arms.

NOTE:  If you open or close the door, hood, or trunk during the 30-second
       exit delay, the system restarts the 30-second delay.

Remote Arming

To arm the system from outside the vehicle, press ARM on the transmitter.
The system announces, "System Armed" and the red indicator lights steadily
when the system is armed.

The transmitter has a maximum range of about 100 feet (30 meters).  The
actual range depends on your installation, the location of nearby metal
objects, and the strength of the remote transmitter's battery.

DISARMING THE SYSTEM

The method for disarming the system depends on the method you used to arm
it.

Automatic Disarming

If you open a door after automatic arming, the system begins a 12-second
entry delay.  During this delay, disarm the system in either of two ways:

    Turn on the ignition

    Press DISARM on the transmitter with the ignition off.  The 
    system announces, "System Disarmed, alarm was triggered."

Remote Disarming

If you armed the system with the remote transmitter or if the system 
armed itself automatically, you must disarm it with the remote transmitter
from outside the vehicle (with all the doors closed).

Press DISARM on the transmitter.  The system announces, "System Disarmed"
if you disarmed it before or during the alarm, or "System Disarmed, alarm
was triggered" if you disarmed it after the automatic alarm reset.

NOTE:  The transmitter will not function when the ignition is turned on or
       set to the accessory (ACC) position.

TURNING THE VALET FEATURE ON AND OFF

You might not want the system to automatically arm when you use valet
parking or when you put your vehicle in a repair shop.

To turn on the valet feature, press VALET on the remote transmitter.  The
system announces, "Valet on".  The green indicator flashes slowly and the
system does not arm.

To turn off the valet feature, press VALET on the remote transmitter again.
The system announces, "Valet off" and the LED stays solid green.

TURNING THE VOICE ON/OFF

You can turn off the system's voice and have it sound beeps instead.  To
turn off the voice, press VALET and ARM at the same time with the system
disarmed.  The system beeps three times.

To turn the voice back on, press VALET and ARM again with the system
disarmed.  The system announces, "Thank you."  

The system either announces messages or sounds beeps.

              VOICE                          BEEP

     Remote code is being learned.           Once

     Thank you.                              Twice

     Valet on.                               Four times

     Valet off.                              Twice

     System armed.                           Once

     System disarmed.                        Twice

     This vehicle is equipped with           Alarm sounds for
     an alarm.  Please step back.            3 seconds

     System disarmed.  Alarm was             Two sets of three
     triggered.                              beeps

SYSTEM STATUS INDICATORS

              STATUS                         INDICATOR

     Armed                                   Solid red

     Armed and alarm is sounding             Slowly flashing red

     Valet on                                Slowly flashing green

     Exit delay                              Quickly flashing red

     Entry delay                             Slowly flashing red

     Disarmed and alarm sounded              Slowly flashing green
     during last alarm cycle*                and yellow

     Valet on and DISARM was pressed
     during or after panic alarm             Slowly flashing yellow

     Disarmed or ignition ON                 Solid green

*NOTE:  To clear the indication that the alarm sounded during the last
        cycle, turn the valet feature on and then off, or turn the ignition
        on and off then press DISARM.

Relearning Remotes

Press the learning button on the back of the main alarm unit.  Then press
the button on the remote.


(SP/RF 3/8/96)