Digital Keypad
(490-0452)                 Installation               Faxback Doc. # 17354

NOTE:  Install the keypad indoors away from dust, dirt and temperature or
       humidity extremes.

Follow these steps to install the keypad.

1.  Select a location on the wall that is not directly over a wall stud.

    NOTE:  Radio Shack stores sell an electronic wall stud finder.

2.  Using a single-gang electrical box as a template, make a hole the 
    size of the box.

3.  Route connection wires from the alarm system to the hole (through the
    attic, walls, and so on) and through a knock-out plug in the electrical
    box.  Leave extra wire for connection to the keypad.

4.  Insert the box into the hole and nail it to the wall stud or use metal
    strips designed for mounting an electrical box in wallboard; the box
    should be recessed slightly below the surface of the wall.

5.  Connect the wires to the keypad and the alarm system terminals.  Refer
    to "Connecting to the Alarm System" (Faxback Doc. # 17353

6.  Remove the screw from the bottom of the keypad.  Then remove the
    keypad's front cover.

7.  Secure the keypad to the box using two screws.  Then replace the
    keypad's front cover and secure it with the screw you removed in
    Step 6.